Omcan Aurora FR-CN-1372E-HC, Instruction Manual

10

Troubleshooting

Problem

Possible Cause

Solution

Compressor not running.

Fuse blown or circuit breaker 

tripped.

Replace fuse or reset circuit 

breaker.

Power cord unplugged.

Plug in power cord.

Thermostat set too high.

Set thermostat to a lower 

temperature.

Cabinet in defrost cycle.

Wait for defrost cycle to finish.

Condensing unit runs for long 

periods of time.

Excessive amount of warm product 

placed in cabinet.

Allow adequate time for product to 

cool down.

Prolonged door opening or door 

ajar.

Ensure doors are closed when not 

in use. Avoid opening doors for 

long periods of time.

Door gaskets not sealing properly. Ensure gaskets are snapped in 

completely. Remove gaskets and 

wash with soap and water. Check 

condition of gaskets and replace if 

necessary.

Dirty condenser coil.

Clean the condenser coil.

Evaporator coil iced over.

Unplug unit and allow coil to 

defrost. Make sure thermostat is 

not set too cold. Ensure that the 

door gaskets are sealing properly.

Maintenance

the fan motor to prevent moisture damage.

CLEANING THE INTERIOR OF THE UNIT

• 

When cleaning the cabinet interior, us a solvent of warm water and mild soap.

• 

Do not use steel wool, caustic soap, abrasive cleaners, or bleach that may damage the stainless steel 

surface.

• 

Wash door gaskets on a regular basis, preferably weekly. Simply remove door gasket from the frame of the 

door, soak in warm water and soap for thirty (30) minutes, dry with a soft cloth and replace.

•  Check door gaskets for proper seal after they are replaced.

• 

Periodically remove the shelves and pilasters from the unit and clean them with mild soap and warm water. 

To remove the pilasters, first remove the shelves and shelf brackets. Then, simply lift the pilaster up and 

out.

Warning: Disconnect power cord before cleaning any parts of the unit.