Omcan B34, Instruction Manual

7

Operation

Maintenance

regulator (optional), maintaining the thickness of the slice desired.

When pulling back the product do not touch the blade avoiding disconnecting it from the wheels.

Drop a little bit of water onto the fixed table to facilitate the slipping of the product.

COMPONENTS ADJUSTMENT

PULLEY BELT

•  The belt must be firmly fixed to prevent it from skidding. Do not tighten it too much because it can wear out 

quickly.

• 

To have access to the belt remove the screws with a screwdriver from the inferior back lid and take it out.

• 

With a screw-wrench loosen the screws turning it counter-clockwise. To stretch out the belt you have to 

push the motor with the wood lever tightening the screws.

IMPORTANT: The pulleys must be lined up.

UPPER BEARING ADJUSTMENTS

• 

The purpose of this adjustment is to centralize the blade on the gear and avoid it falling down.

• 

First of all disconnect the machine from the electricity supply. Then loosen blade turning handle counter-

clockwise.

• 

Take out upper back lid by removing screws using the screwdriver. Loosen the three screw-nuts using a 

10mm screw-wrench.

• 

Using the screwdriver turn the screw-nut ¼ counter-clockwise if the wheel is inclined towards the front or 

turn it ¼ clockwise if it is inclined backwards. Tighten the three screw-nut previously loosen. Calibrate the 

blade according to pre-operation.

• 

Turn the wheels manually to check if the blade is centralized, if it is not keep turning the wheels until the 

blade is centralized.

CUTTING REGULATOR

• 

The cutting regulator (optional) was designed to provide cuts with the same thickness and also to protect 

the operator from getting injured.

• 

To adjust the cutting regulator proceed as follows: 

Turn locking knob counter-clockwise to be able to move the cutting regulator to the left and right according 

to the distance you want to leave from it to the blade.

•  Then turn the locking knob clockwise to fix the cutting regulator in the desired position.

CLEANING

First of all disconnect the machine from power source.

• 

Remove the upper door by unscrewing the screws of the hinges.