Omcan BB-CN-0005, Instruction Manual

7

Installation / Operation

CABINET LOCATION GUIDELINES

•  Install the unit on strong and leveled surfaces. 

- Unit may make unpleasant noises if surface is uneven. 

- Unit may malfunction if surface is uneven.

•  Install the unit in an indoor, well-ventilated area. 

- Unit performs more efficiently in a well-ventilated area. 

- For best performance, please maintain clearance of 4” on the back of the unit. 

- Outdoor use may cause decreased efficiency and damage to the unit.

•  Avoid installation in a high humidity and/or dusty area. 

- Humidity could cause unit to rust and decrease efficiency of the unit. 

- Dust collected on condenser coil will cause unit to malfunction. Clean the condenser at least once a 

month with a brush or clean cloth.

•  Select a location away from heat and moisture-generating equipment. 

- High ambient temperature will cause the compressor to overwork, leading to higher energy bills and 

gradual breakdown of the unit.

ELECTRICAL

Please ensure that the required voltage of the compressor is being supplied at all times. Low or high voltage 

can detrimentally affect the refrigeration unit. All units should be plugged into a grounded and properly-sized 

electrical outlet with appropriate overcurrent protection. Please refer to the electrical requirement on the 

nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord.

TEMPERATURE CONTROLS

The temperature controls are factory-set to maintain an average temperature of 38°F in refrigeration. To 

maintain a different temperature, simply adjust the control knob located inside the unit. To decrease the 

temperature (colder), turn clockwise. To increase the temperature(warmer), turn counter-clockwise – see 

diagram.

LOADING PRODUCT

The bin dividers have been installed at the factory for your convenience. Feel free to reposition the dividers 

as you see fit. To remove the bin dividers, simply push the divider towards the back wall unit the front of the 

divider is removed from the positioning holes. To install, position the divider to the desired holes, making sure 

that the pressure spring is installed properly.

PAY CLOSE ATTENTION TO THE LOAD LIMIT STICKERS LOCATED ON THE INTERIOR WALLS TO THE 

UNIT. DO NOT LOAD PRODUCT ABOVE THE LOAD LIMIT STICKERS OR ABOVE THE TOP CROSS BAR 

OF THE BIN DIVIDERS. LOADING PRODUCT ABOVE THE LOAD LIMIT STICKERS WILL HARM THE 

PERFORMANCE OF THE UNIT.