Omcan BS-VE-3200-SS, Instruction Manual

7

is a risk of them catching on the tape.

Before starting to use the butcher bone cutter, carefully read the instructions given by the manufacturer 

regarding the limits of the thickness, hardness and size of the elements of this machine, which by the way, only 

you can use to cut the materials indicated in the instructions.

When making the cut, do not push the saw blade to the piece to be cut. It must be the blade that moves by 

itself through the meat or bone with the help of light pressure. Forcing the cut too much can cause the saw 

blade to break.

HOW TO CLEAN

One of the most important steps for the proper functioning of a band butcher saw is cleaning it. The continuous 

cutting of materials creates waste that can accumulate in the spaces of the machine.

A handheld vacuum cleaner can be used to remove the remains of the pieces that have been cut on the band 

saw, or even special brushes for this.

It is important to check each corner and space to make sure that everything is very clean, especially the gap in 

which the saw crosses, since many debris accumulate there. It is advisable to do this every time the cutter is 

used.

MAINTENANCE

To keep the band saw ready to work at all times and to ensure that its life is longer, it is necessary to carry out 

periodic inspections in addition to maintaining its good conservation.

To keep the saw in the correct position and to ensure smooth and clean cuts, the positioning of its guides 

should be checked. To do this, check that they are only touching the body of the saw. If they have lost 

thickness or are too tight, they will have to be changed or added some sheets that can compensate for wear. 

This will make precise cuts.

Another part that must be taken care of to ensure that the band saw does its job well is aligning the flywheels, 

which are responsible for supporting the main body of the machine. You have to achieve equality between 

the two so that they hold and keep the band saw in place. The tools that are in charge of holding the piece to 

be cut are the dams and they have to remain with a level of firmness and correct adjustment. In this way the 

material will stay in place, so its correct maintenance is also essential.

Operation

Maintenance