7
Installation
Operation
Maintenance
•
Place the device on top of an even and stable surface which supports the weight of the device and is not
heat sensitive. At no time should you place the device on a flammable surface (such as table cloth, carpet,
ect).
• You must not position the device near any heat sources (such as open fireplaces, electric ovens, ect).
•
Position the device in such a way that the plug can be easily accessed.
• Before first use, clean the inner sides and the grids with a soft cloth and a mild cleaning agent. Afterwards,
dry the device thoroughly.
• Remove the water bowl from the device to fill with water.
SET TEMPERATURE
1. Press the SET button, the set temperature is displayed. Press the UP or DOWN buttons to modify and
store the displayed value. Press the SET button to exit the adjustment and display the internal temperature.
If no button is pressed within 10 seconds, the display shows the internal temperature.
2.
Illumination: Press the LIGHT button, the light turns on, press it again and the light turns off.
3.
Heating Indicator: During heating, the LED is on, when the temperature inside is constant, the LED is off.
• Set the temperature as required for respective foods. You may adjust the desired temperature in the range
between 30 - 90°C (86 - 194°F).
•
The temperature inside can be read from the front display.
•
Put the foods in appropriate containers before placing them inside the hot display and shut it by using the
sliding door.
•
Some of the device parts become very hot, always use safety gloves when placing or removing food.
• Switch on the inner light when required by using the light switch on the device.
•
Disconnect the device from the power socket when the device is not in use.
•
Before beginning with repair or cleaning, make sure the device has been disconnected from the power
socket and has cooled down completely.
•
Don’t use any acidic agents and make sure no water enters the device.
•
To protect yourself from electric shock, never immerse the device, its cables or the plug in water or other
liquids. Don’t use any kind of pressure water jet for cleaning the device.
Summary of Contents for DW-CN-0120-5
