7
Operation
Maintenance
• Before first use, clean the inner sides and the shelves with a soft cloth and a mild cleaning agent.
Afterwards, dry the device thoroughly.
• Remove the water bowl from the device. The water bowl is installed inside the device and then fill the water
bowl with water.
•
Connect the device to a single grounded power socket.
• Set the temperature as required for respective foods. You may adjust the desired temperature in the range
between 30°C-90°C / 86°F-194°F.
•
The temperature inside of the hot display can be read from the front display.
•
Put the foods in appropriate containers before placing them inside the hot display and shut it by using the
sliding door.
•
Some of the device parts become very hot, always use safety gloves when placing or removing foods.
•
The foods are kept warm at the temperature set by you previously.
•
In order to place or remove foods, you may open the door at rear side.
• Switch on the inner light when required using the light switch of the device.
•
Disconnect the device from the power socket when the device is not in use.
•
Before beginning with repair or cleaning, make sure the device has been disconnected from the power
socket and has cooled down.
•
Do not use any acid agents and make sure no water enters the device.
•
To protect yourself from the electric shock, never immerse the device, its cables or plug in water, or other
liquids.
•
Do not use any kind of pressure washer jet for cleaning the device.
CLEANING
•
The device should be cleaned regularly.
•
Clean the device from the inside and outside with a soft, damp cloth and a mild cleaning agent.
•
Clean the shelves and the housing with a soft, damp cloth and a mild cleaning agent.
• Clean the water bowl regularly. Calcifications on the water bowl may be removed with common agents or
liquids.
•
Only use a soft cloth and make sure you never use any kind of abrasive agents or pads which could
scratch the surface.
•
After the cleaning procedure, you should use a soft, dry cloth to wipe dry and polish the surface.
•
Make sure the device has been cleaned properly before storing it in a dry place.
MAINTENANCE
•
Check the mains lead from time to time to ensure it is not damaged in any way. Never use the device if the
lead is damaged. If the lead is damaged, it must be replaced by a qualified electrician.
• Only a qualified technician should carry out repairs and maintenance of the device. Do not attempt to repair
