13
Maintenance
DISCS
With time the blade could wear:
•
For DTV, DT 2, 3, 4, 7, 9 and PS 6, 8, 10, 20 discs; it is necessary to buy new discs.
•
For DF 1, 2, 3, 4, 5, 8, 10, 14 and DQ 4, 6, 8, 10 discs, it is possible to replace the blade.
In this case, call Omcan indicating the name of the disc.
TROUBLESHOOTING
The fixing of the discs is faulty:
Check that the discs and the disc support pin are clean.
The lid does not lock:
Check that the lid is installed correctly and that it is clean.
The product is not cut correctly:
Check that the blade is not worn.
The product does not go out correctly or is badly cut:
Check that the discharging spatula has not been
assembled with the DT discs (the whole set); DF 1, 2, 3, 4; DQ 4; that the bowl is not full and that the exit
opening is not obstructed.
The machine locks:
Check that the product is not frozen or too hard and that the power supply is the one
indicated on the rating plate.
The micro on the pusher handle and on the lid do not work:
Check that they are not dirty.
The machine does not start:
Check that all the safety devices are correctly installed and that the plug and the
switches are correctly connected.
CLEANING OF THE MACHINE
IMPORTANT
• The machine must be cleaned at least once a day. If necessary clean when required during the day.
•
All the Vegetable cutter parts that come into contact directly or indirectly with the food product must be
cleaned thoroughly.
Before starting cleaning operations, it is necessary to:
•
Disconnect the machine plug from the mains to isolate it from the mains power supply.
Pay attention to hazards of injury caused by cutting and/or sharp machine components during
cleaning or handling of discs.
CLEANING PRODUCTS - CAUTION!
The machine must be cleaned with a normal detergent at ambient temperature, with a wet cloth. It must never
be cleaned with pressurised water, or water jets, do not use brushes or other tools or anything that could
damage the machine.
NOTE: NEVER WASH THE MACHINE PARTS IN THE DISHWASHER.
IMPORTANT: Disconnect the machine from the power supply. Remove the lid and the discs, the
spatula, the pestle, the bowl and/or the chute. Clean accurately the inside of the mouth, the operating
area and the disc support pin. Moreover clean all the external surfaces and the pusher handle. Dry with
a cloth and reassemble the machine.
