Omcan HLC300, Instruction Manual

5

Installation

Operation

OMCAN DECLINES ANY AND ALL RESPONSIBILITY FOR DIRECT AND INDIRECT 

DAMAGES WHICH MAY ENSUE FROM NOT COMPLYING WITH THE REGULATIONS. 

THE CUTTING MACHINE IS MANUFACTURED INTO 110V/1/60HZ SETTINGS.

WARNING: OPEN THE COVER, ROTATE THE SIDE HANDLE AND REMOVE THE 

CUTTING DISC (IF ANY) WITH THE MACHINE STOPPED, (OR WITH THE WHITE 

PLASTIC EJECTOR ONLY), THROUGH THE UPPER (ROUND) OPENING. BY PRESSING 

THE START GREEN BUTTON FOLLOWED BY THE RED STOP BUTTON, CHECK TO 

MAKE SURE THE CENTRAL PIN DIRECTION OF ROTATION IS COUNTERCLOCKWISE. 

IF THE DIRECTION OR ROTATION IS NOT CORRECT, REVERSE THE SUPPLY WIRES.

SAFETY MEASURES AND TRAINING 

The skilled personnel in charge of the installation and electric connections of the equipment is responsible for 

the training of the operator and informing the operator of all safety measures to comply with. This instruction 

manual comes with each unit.

CONTROLS

The controls and pilot light are on the right side of the base when the 

machine is located in front of the operator.

1.  Green button for starting the machine.

2.  Red button for stopping the machine.

Pic. 2

Pic. 3