14
Maintenance
WINTERING
• Turn off the water and power supply, drain the residual water from the water trough, inlet pipe and drain
pipe.
Note: The maintenance of the ice machine is not covered by the manufacturer’s warranty!
CLEAN FUNCTION
Note: Please empty the bin of ice in advance.
Note: Please clean and sterilizing the bin and do complete rinsing.
Note: Please clean and sterilizing the ice sliding board, water distribution pipe, water supply pipe,
water pump, then do complete rinsing.
• Turn on the ice maker; push “clean” button for 3 seconds, the ice maker will get into clean process. Put in
proper amount of clean solution manually followed by the clean and sterilizing process instruction.
• Push “clean” button. The ice maker will do auto clean for about 15 minutes. Please do spray cleaning to
the evaporator at the mean time to insure a complete clean. When finished, the led display flashes “Clean”
slowly again.
• Put in proper amount of sterilizing solution manually followed by the clean and sterilizing process
instruction. Push the “clean” button again, the ice maker will do auto sterilizing for about 15 minutes. Please
do spray sterilizing to the evaporator at the mean time to insure a complete sterilizing. When finished, the
ice maker will get into rinsing process, the process will take about 5 minutes, and do 5 cycles rinsing.
• The ice maker will get back to do ice making as soon as the clean process end.
• Please throw away the next 5 batches ice in case of cleaner remained.
SERVICE CALL
If the ice machine works abnormally, please confirm below before making a service call:
1. Check the water supply.
• Whether there is water in the water trough.
• Whether the water pressure for the ice machine is 1.3 Bar to 5.5 Bar; the water temperature is 5-35 °C.
• Whether the water valve is open.
• Whether there is no water leakage.
2. Check the power.
• Whether the panel display does not display the OFF standby state.
• If the LED on the display panel is blank or “OFF”, check whether the plug and socket are normal, and
whether the power supply switch is ON.
3. Check nameplate and series number.
• Check the nameplate located on the side or back of the ice machine and record the model and series
number of the ice machine.
Note: If the machine fails due to the user’s faults, such as no supply of water, electricity or
environmental factors, rather than the fault of the ice maker, the door-to-door service will be
charged.
