9
Maintenance
Troubleshooting
Follow the steps as listed:
FREQUENCY
PERSONNEL
SOLUTION
At the end of
every use and
before daily use.
Operator
DISINFECTION
• Use PH neutral detergents.
•
Use demineralized water if temperatures exceed 60°C/140°F.
• If any other products are used, they must be adequate to the
materials being disinfected.
PERIODS OF LONG INACTIVITY
•
If the machine has been inactive for a long period of time, vigorously
wipe the machine with a cloth soaked in Vaseline to create a
protective barrier.
PRODUCTS NOT TO USE:
•
Compressed or pressurized air jets.
• Vapor equipment.
•
Detergent that contains any of the following compounds:
- Bleach.
- Hydrochloric acid.
- Products that are used to clear drains.
- Caustic soda products for cleaning marble.
- Etc.
•
Steel wool, brushes or abrasive discs produced with other metals or
alloys, or tools that have previously cleaned other metals or alloys.
•
Detergents in abrasive dust.
• Fuel, solvents or inflammable and/or corrosive fluids.
•
Substances used to clean silver.
The following indicated problems that may occur:
TYPE
POTENTIAL CAUSE/S
SOLUTIONS
The electrical supply is not
adequate.
General blackout.
Contact an electrician.
Blown fuse.
Replace the fuse, if the problem
continues, contact an electrician.
The machine stops.
The protection device stops the
machine.
Contact an electrician to eliminate
the causes, once the cause has
been determined, restore the
machine to the recommended
function.
The cause could not be identified.
Contact Omcan directly.