8
Operation
Maintenance
4.
Adjust the slice thickness. Activate the blade (10) by pressing the on button. Grip the product holder handle
(14) and begin alternative cutting motion.
5. At the end of cutting operations return the slice thickness adjustment knob to the safety position and pull
the carriage back. Stop the blade motion by pressing the off button (2).
CLEANING
Keep the machine thoroughly clean. If used, it should be cleaned at least once a day and more often if
necessary. After a period of inactivity, the machine should also be cleaned before use.
Risk of electric shock! Before cleaning the machine, disconnect the plug from the electrical mains
socket and return the slice thickness adjustment knob to the safety position.
WARNING! Blade is sharp, cutting hazard! Check that the slice thickness adjustment knob (5) is in the
safety position (in position 0) (Fig. A).
CLEANING PRODUCTS
Use only water and biodegradable foaming detergent for dishwashers with PH 7-8, using a soft, spongy cloth
and a semi-rigid nylon brush for the sharp areas of the table and product holder. Do not clean the machine with
jets of water or steam or similar methods.
TABLE TILTING FOR CLEANING OPERATIONS
1.
Make sure that the machine is switched off.
2. Make sure that the lever is closed.
3. Pull the meat table (8) back all the way toward the operator.
4.
Gradually push the table upward, rotating it clockwise.
WARNING! Blade is sharp, cutting hazard! Always return the table to its initial position so that the
protection (7) is as close to possible as the gauge plate (Fig. B).
REMOVING
THE BLADE COVER
• Rotate the blade cover 90° anticlockwise using the special knob.
• A spring facilitates the extraction of the blade cover (Fig. C),
THE PRODUCT HOLDER
•
Unscrew the product holder handle in the anticlockwise direction until the product holder is completely
removed.
WARNING! Blade is sharp, cutting hazard! Use protective gloves when cleaning sharpening areas, the
Summary of Contents for MS-IN-0250H-R
