10
Installation
13. Slide Φ8 washers (GG) over the threaded ends of reflectors spacers (FF). Attach reflector assembly to
head assembly (C). Place Φ8 washers (GG) over threaded ends of reflector spacers (FF) sticking out
through reflector assembly and secure with wing nuts (KK).
Note: Do not overtighten.
14.
Screw gas hose (K) and regulator (L) onto propane cylinder (not included). Do not cross-thread. Place the
propane cylinder into the cylinder housing (H), then close the door (I).
WARNING: Use a standard 20 lb. propane cylinder only.
A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your cylinder
supplier. Never use a propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in accordance with the specifications for LP gas
cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders, spheres and tubes for
transportation of dangerous goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the heater.
•
Do not store a spare LP-gas cylinder under or near this appliance.
• Never fill the cylinder beyond 80 percent full.
•
Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type
of dust cap on the cylinder valve that is provided with the cylinder valve. Other type of caps or plugs may
result in leakage of propane.
