14
Maintenance
WARNING - FOR YOUR SAFETY:
• Do NOT touch or move heater for at least 45 minutes after use.
• Reflector is hot to the touch.
• Allow reflector to cool before touching.
CARE AND MAINTENANCE
•
Keep exterior surfaces clean.
• Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
• While cleaning your unit, be sure to keep the area around the burner and pilot assembly dry at all times. Do
not submerge the control valve assembly. If the gas control is submerged in water, do NOT use it. It must
be replaced.
• Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors
and liquids.
• Do not obstruct the flow of combustion and ventilation air.
•
Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.
• Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean.
• Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render
it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear
away smaller particles.
• Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if any
carbon deposits develop.
NOTE:
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.
Frequently check for corroded areas and repair them promptly.
• Use high-quality automobile wax to help maintain the appearance of the heater. Apply to exterior surfaces
from the pole down. Do not apply to emitter screen or domes.
BETWEEN USES
•
Turn Control Knob OFF.
•
Disconnect LP source.
•
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet,
hail, snow, dust and debris).
•
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
NOTE:
Wait until heater is cool before covering.
DURING PERIODS OF EXTENDED INACTIVITY OR WHEN TRANSPORTING
•
Turn Control Knob OFF.
•
Disconnect LP source and move to a secure, well-ventilated location outdoors.
•
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet,
hail, snow, dust and debris).
•
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
Never leave LP cylinder exposed to direct sunlight or excessive heat.
NOTE:
Wait until heater is cool before covering.
