9
7.
Attach reflector spacers (FF) and Ø8 washers (GG) to the top of head assembly (C). Tighten the reflector
spacers (FF).
8. Unscrew stainless steel bolts (LL) from head assembly (C).
9. Insert hose of head assembly (C) into post (J). Secure head assembly (C) to post (J) with stainless steel
bolts (LL).
Note: The control knob on head assembly (C) should be above the decal on post (J).
10. Remove protective cover from reflector panel (A) and reflector plate (B).
Note: In order to achieve proper alignment of reflector sections, it may be necessary to loosen the
preassembled bolts prior to assembly and retighten once complete.
11. Attach reflector panels (A) together using M6 x 10 mm screws (II) and Φ6 washers (HH). Secure loosely
with cap nuts (JJ).
12. Attach reflector plate (B) to reflector panels (A) using M6 x 10 mm screws (II) and Φ6 washers (HH).
Secure loosely with cap nuts (JJ). Once properly aligned, tighten all screws and the preassembled bolts.
Installation
