7
Installation
space of 70-80 centimeters in order to guarantee easy use of the machine and its cleaning (Fig. 9).
• Please check that the voltage of the machine which is written on the identification label, matches the one
foreseen by the system on your premises.
•
Attach the right plug to the machine power cable in order to make the electrical connection to the system.
•
After mating the plug to the mains socket, the machine is ready for use. First, however, check out proper
operation of all moving parts and components of the machine.
WARNING:
During the machine’s operation, in order to obtain a product with the right thickness and humidity,
avoid air currents which will cause precocious drying of the product together with its deterioration.
INSTALLATION OF THE DRAWPLATE AND START-UP OF PRODUCTION
Before performing the installation an dproduction, make sure the machine is switched off.
• Withdraw the drawplate (Fig. 5A) requested by the container filled with water where it was put after its last
use.
•
Thoroughly rinse with plenty of running warm water in order to have the piece at the right temperature.
Dry it with a soft cloth.
• Unscrew the blocking ring nuts (Fig. 5B and 6A) and carefully clean the internal part including the edging.
• Take the plastic cap off (Fig. 5C and 6B).
• Disassemble the drawplate (Fig. 7A).
•
Screw in the ring nuts by hand and verify that all the pieces are in their places and that they are aligned
along the axle.
•
In order to start production, position the selector on the
position (Fig. 3D) and push the start button (Fig.
3B).
•
The initial product coming out of the machine has an unacceptable look; this is the reason why it has to be
eliminated.
• After a short time (a couple of minutes) the product coming out is acceptable, the colour goes from whitish
to yellow and it has a greater thickness. The cut of the pasta at the desired length can be made by hand or
by knife. In the first case it is usually long length noodles (spaghetti or tagliatelle) and in the second case is
especially short noodles (macaroni, etc.).
At the end of the operation:
• Stop the machine by switching the selector to the “0” position (Fig. 3C) and then turn it on the kneading
position (Fig. 3A) for 10-15 seconds so that the pressure on the drawplate, caused by the product itself,
is eliminated.
• Switch the selector to “0” (Fig. 3C) or push the Stop button (Fig. 3E).
•
Disassemble and wash the moving pieces and clean the machine.
CONTROL OF THE INSTALLATION
Verify that:
• In the “0” position (Fig. 3C), all the elements of the machine have to stop.
• In the “drawplate position” (Fig. 3D), the mixer rotates in a counterclockwise direction and the Archimedean
screw must rotate in the opposite direction.
• In the “knead” position (Fig. 3A), the parts must rotate in the opposite direction.
NOTE:
Every drive is voluntarily run by the start button, when the bowl cover is closed (Fig. 10F).
