10
Operation
going through a drawplate.
USE OF THE MACHINE
Only after making sure that the machine is completely clean, especially all the parts which are directly in
contact with the product (extrusion sleeve, Archimedean screw, pool, mixer, drawplate, knife, lid, control
system; if it is necessary, use some warm water; see Maintenance section) you can carry out the requested
operations in order to have the desired dough.
CONTROL PANEL KEY
1
KNEAD÷DRAW selector
2
Start button
3
Start pilot lamp
4
Stop push button
5
Fan switch
6
Fan pilot lamp
7
Cutter switch
8
Cutter operation pilot lamp
9
Cutter speed variation control
10
2nd tank mixer control stop button
11
2nd tank mixer control start button
12
2nd tank mixer operating pilot light
13
Tank lowering button only for TRD
14
Tank lifting button only for TRD
15
Emergency stop button only for TRD
1. After having turned the machine off:
• Switch the selector to the “0” position (Figure 20A) and check the correct set-up of the Archimedean
screw, making sure that the cylinder part is sustained by the dragging shaft.
• Then make sure that the plastic cap (Figure 21A) which replaces the drawplate is correctly positioned
Summary of Contents for PM-IT-0008
