Omcan PT-CN-1270-HC, Instruction Manual

12

Controller Instructions

Table of Functions activated by the buttons - Models S, X, Y, C (Table 2)

Button

Normal Operation

Start Up

Pressing the Button Alone Pressed Together

Up

ON/OFF

More than 3 sec: toggle ON/

OFF

Start/Stop 

continuous cycle

-

Down

Defrost

More than 3 sec: start/stop 

defrost

Pressed 

together

Start parameter 

reset procedure

For 1 sec. 

display 

firmware 

vers. code

Set Mute - 1 sec.: display/set the set 

point.

- more than 3 secs.: access 

parameter setting menu 

(enter password )

- mute audible alarm 

(buzzer)

-

For 1 sec. 

RESET cur-

rent EZY set

Setting the set point (desired temperature)

• press 

SET

 for 1 sec, the set value will start flashing after a few moments;

• increase or decrease the value using 

UP

 or 

DOWN

;

• press 

SET

 to confirm the new value.

Switching the device ON/OFF

Press 

UP

 for more than 3 sec. The control and defrost algorithms are now disabled and the Instrument 

displays the message “OFF” alternating with the temperature read by the set probe

Manual defrost 

Press for 

DOWN

 more than 3 sec (the defrost starts only the temperature conditions are valid).

Continuous cycle

Press 

UP

 and 

DOWN

 together for more than 3 sec

Access and setting type F (frequent) and type C (configuration) parameters

1.  press 

SET

 for 3 sec (the display will show “PS”);

2.  • to access the type F and C parameter menu, enter the password “22” using 

UP/DOWN

, press 

SET

 to 

confirm; 

• to access the F parameter menu only, press 

SET

 (without entering the password);

3.  scroll inside the parameter menu using 

UP/DOWN

;