6
Safety and Warranty
Sufficient space
The distance from both sides and back of refrigerator
to wall or other substance must be no less than 10
cm (4”). The refrigeration capability may decrease if
its surrounding space is too small to circulate air.
Well ventilated
Always place the refrigerator in an area with proper
ventilation. When using for the first time, wait at least
24 hours after handling to start.
Far from heat source
Never place the refrigerator in direct sunlight. Never
place refrigerator near heat source as it reduces
refrigeration capabilities.
Heavy load
Never put any heavy objects on top of the
refrigerator.
Do not make holes
Never make any holes on the refrigerator. Do not
attach any objects onto the refrigerator.
Stable Location
Unpack and place the refrigerator on level and stable
ground.
Exclusive power socket
Normally, the power supply should be 100 – 120V,
60 Hz single phase AC with exclusive single phase
receptacle.
Do not share the socket
Never let the refrigerator share a socket with another
appliance. The cable may become hot and this may
cause a fire.
DO NOT USE EXTENSION CORDS.
Protect cables
Never break or damage the cables as this may cause
current leakage resulting in a fire.
No water flushing
Never spray down refrigerator with pressurized water
supply.
Avoid flammable and explosive objects
Never put any flammable or explosive items inside
the refrigerator such as gasoline or alcohol. Never
put any dangerous products in close proximity to the
refrigerator.
No spray
Do not spray the unit with a flammable substance
such as paint. This may result in a fire.
After power break
After a power break or unplugging the refrigerator,
always wait at least 5 minutes before starting the
refrigerator again.
Medical Storage
No medicine is allowed to be kept inside the
refrigerator.
SUITABLE FOR HIGH TRAFFIC AREAS WHERE NOISE LEVELS ARE NOT A CONCERN.
NOTE
• The electric circuit diagram and parameters on the product name plate are subject to change without the
manufacturer having to change the manual.
• The design might be improved without notice.
• If the power cord is damaged, it must be replaced by the manufacturer, its service agent or a qualified
electrician in order to avoid injury.
WARNING: The unit uses R290 refrigerant. Make sure that all precautions against fire
have been taken.
Summary of Contents for RS-CN-0468
