Omcan Santos 09, Instruction Manual

7

Operation

Note: removing the drawer (1) or lifting up the chute (3) stops the appliance from working (figure 6).

For easier cleaning, do not leave food to dry in the drawer or on the grating disc.

CHANGING DISC

Push the end of the lever (4), pull on the closing key (14) and remove the chute + lever unit to get to the disc 

(6) (figure 2).

TAKING APART (LEFT-HANDED THREAD): (FIGURE 3)

•  Clamp the disc (6) and undo the screw (7) following the arrow (clockwise) with the closing key (14).

REASSEMBLING: (FIGURE 4)

•  Check that the key (8) is present on the motor shaft.

•  Check that the seal (13) is present on the disc (6).

•  Place the disc on the motor shaft making the key match the key groove.

•  Clamp the disc (6) and tighten the screw (7) following the arrow (anti-clockwise).

ADJUSTING THE ICE CRUSHER: (FIGURE 5)

It is possible to adjust the position of the knife on the ice crusher disc by loosening the 2 fastening screws (9) 

fixing the knife (10) onto its support (11) and by moving it to increase or to reduce the cutting height of the knife 

into the ice cube. Tighten the 2 screws (9) carefully after adjusting.

SAFE ACCESS TO THE TOOLS: (FIGURE 6)

The appliance can only start if the lever (4) is not extending out of the chute to insert the food (3) and if the 

drawer catching the food (1) is correctly placed on the slideway (2).

Removing the drawer (1) causes the machine to stop. Re-starting the appliance requires specific operation of 

the On / Off switch (5) again (position 1).

A cut in the mains power supply results in the On / Off switch (5) stopping (position 0).

The fact of lifting the lever to add food into the chute (3) causes the motor to stop, without causing the 

appliance to stop completely.

Lowering the lever (4) allows the motor to be restarted.