Omcan Santos 09, Instruction Manual

8

Maintenance

Before carrying out any work on the appliance, it must in all cases be unplugged from the mains power 

supply and the motor start capacitor discharged.

DISCHARGING THE CAPACITOR

Use a screwdriver with insulated handle to touch the 2 connectors on the capacitor (12). The appearance of an 

electric arc shows that the capacitor has discharged.

SPARE PARTS

IMPORTANT: Use of spare parts other than certified original SANTOS parts is prohibited.

This machine requires no specific maintenance. The bearings are lubricated for life. If work is required to 

replace worn parts such as start relay or the electric or other components, refer to the parts list.

For all spare part orders (see references in the exploded view at the end of the manual), state:

•  The type.

•  The machine serial number.

•  The electrical specifications recorded under the machine.

The complete disc (6) can be considered to be a part subject to wear.

For the machine to operate properly, it is recommended that a check is also made that the seal (13) is in good 

condition, in particular the absence of any signs of tearing of the lip.

CLEANING

The appliance should neither be cleaned in a jet of water nor with a high pressure spray.

1.  Put the appliance on stop position by pushing the On/Off button and disconnect the plug.

Operation

MOTOR OVERLOAD SAFETY FEATURE:

Should the motor become blocked (foreign body, object that is too hard, too much pressure with the lever on 

the products being processed), the On / Off  switch (5) automatically trips to the 0 position.

Correct the problem and press the On / Off switch (5) (position 1).

If the problem persists, switch off the power supply to the machine (unplug the cord from the mains socket) and 

call in the maintenance service or contact a SANTOS approved dealer.