background image

3. Use and maintenance manual 

B01.10-B01.12

San Maurizio C.se - 11/07/2018

www.omcr.it

1. RISKS EVALUATION

The matters of following pages refer to a classic use of lifting brackets and they can’t forecast unspecified 
applications. For this reason each user must provide to his own risks evaluation and he must consider this manual 
as general reference support  and as a summary of possible matters. To define the employ-procedures, to spread 
information and to check the compliance of these ones it’s a duty and a responsibility of the user.
The lifting brackets have to be used as couplets for ropes and they allow users to make on safety the following 
actions: 

LIFTING

 / 

HANDLING

 / 

OVERTURNING

; the material, the production and the quality-check of all OMCR 

lifting pins comply with the Directive 

2006/42/EC

 requirements; all OMCR lifting elements have been tested with a 

static safety factor even to a minimum 1.5, all materials have been analyzed according to 

UNI EN 10204

, samples 

of all materials have been subjected to tensile stress test according to 

UNI EN 10002

Calculations and risk 

assessments have been made according to VW-AUDI, BMW, MERCEDES-BENZ, VDI3366 norms.

An improper or opposed use in reference to the prescriptions treated in this manual, deletes this EC 
conformity declaration and relieves OMCR from any responsibility.

WARNING

According to ISO 3864-2, ANSI Z535.6, ANSIZ535.4 norms, in this manual are classified the following safety 
messages and symbols:

2. SYMBOLS AND WARNINGS CLASSIFICATION

WARNING

WARNING

NOTE

It indicates a hazardous situation which, if not avoided, could result 

in death or serious injury.

It indicates a hazardous situation which, if not avoided, could result 

in minor or moderate injury.

It indicates advices on use or other especially helpful informations.

It indicates general warning symbol.

It indicates hazard of crushing consequent to an accidental fall or overturning 

of the load.

It indicates hazard of crushing.

It indicates musculoskeletal disorders for the handling of the loads.

It indicates forbidden actions or uses.

It indicates mandatory actions to avoid hazards.

It indicates that it is forbidden to stop or to transit.

Summary of Contents for B01 10 016











Reviews: