(g). Press "
" key to store the alarm high limit value and to enter
the alarm low limit value setting, the symbol “ ” is displayed.
(h). Press or key to set the desired alarm low limit value, the
resolution of setting value is 0.1 degree, regardless of the
temperature units.
(i). Press "
" key to store alarm low limit value. You can store
individual alarm High / Low limit values for T1, T2, T3 and T4,
by repeating (c) to (i) procedure.
(j). Press “
SET
” key to exit this mode.
(k). Press “
ALARM
” key to enter the alarm function, the
“
ALARM
” symbol is displayed. When the measured
temperature value exceeds the setting High temperature
value (the “ ” symbol will flicker the display) or below the
setting Low temperature value (the “ ” symbol will flicking
display.) the beep will sound one time per 4 seconds.
(l). Press “
ALARM
” key again to exit the alarm function.
4-2 Setting the Thermocouple Type
1. Press " " key to turn on the meter.
2. Press “
TYPE
” key to enter the thermocouple type choices.
The currently selected thermocouple type blinks.
3. Press or key to select the desired T1, T2, T3 or T4.
4. Press or key until the thermocouple type you want
appears on the display.
5. Press "
" key to store the thermocouple type. You can
store individual thermocouple types for T1, T2, T3 and T4, by
repeated (3) to (5) procedure.
6. Press “
TYPE
” key again to exit this choices.
4-3 Temperature Measurement
1. Press " " key to turn on the thermometer.
2. Plug the thermocouple (s) into the thermocouple input. If no
thermocouple is plugged into the selected input or the
thermocouple is "open", the display will show "- - -".
~ 10 ~
