BURN OUT NOTIFICATION
If the sensor is not connected or over measurement range, the
「
- - -
」
will be displayed on LCD and the data in
the SD card is “0”.
TROUBLE SHOOTING
Q1: Wrong temperature??
A1: Refer to page 4 (TEMPERATURE PROBE TYPE), you must select the correct temperature sensor type or
adjust temperature manually (Long press UNIT button then press UNIT to select “not”).
Q2: Appear “Error codes”??
A2: Make sure if Hold
appears
on LCD.
ERROR CODES
Code
Description
- - -
The electrode were not in a solution. Dashes in the temp. mode indicates that probe without
ATC or manual temp. setting. The electrode of cond. measured in pure water or ultra pure water.
Select the wrong temp. probe type (refer to page 4).
OL2
Measurement is out of range of the display.
11
