PLATINUM
TM
Series User’s Guide
30
Reference Section: Initialization Mode (INIt)
Navigate to the correct setting. Settings include the following:
•
bUS.F
– Specify RS232 or RS485 serial communications
•
bAUd
– Baud rate (transmission rate)
•
PRty
– Parity (used for transmission error checking)
•
dAtA
– Number of bits per data point
•
StoP
– Number of stop bits between data points
Select the desired setting.
4.4.3.1
Serial Bus Format (INIt > CoMM > SER > C.PAR >
bUS.F)
Select the Bus Format (
bUS.F
) parameter.
Navigate to the desired setting. Settings include the following:
•
232C
– Allows one-to-one serial communications (factory default)
•
485
– Allows multiple devices to operate on a single pair of wires
Select the indicated option.
4.4.3.2
Baud Rate (INIt > CoMM > SER > C.PAR > bAUd)
Select the Baud Rate (
bAUd
) parameter. The device being communicated to
determines how fast you can set the Baud Rate.
Navigate to the desired setting for Baud rate (bits per second):
•
19.2
– 19,200 Baud (factory default)
•
9600
– 9,600 Baud
•
4800
– 4,800 Baud
•
2400
– 2,400 Baud
•
1200
– 1,200 Baud
•
57.6
– 57,600 Baud
•
115.2
– 115,200 Baud
Select the indicated option.
4.4.3.3
Parity (INIt > CoMM > SER > C.PAR > PRty)
Select the Parity (
PRty
) parameter.
Navigate to the desired setting. Settings include the following:
•
odd
– Odd parity used to verify communications (factory default)
•
EVEN
– Even parity used to verify communications
•
NoNE
– Parity is not used to verify communications
Select the indicated option.
4.4.3.4
Data Bits (INIt > CoMM > SER > C.PAR > dAtA)
Select the number of Data Bits (
dAtA)
.
Omega Engineering | www.omega.com
