PLATINUM
TM
Series User’s Guide
59
Approvals Information
8.
Approvals Information
This product conforms to the EMC directive 89/336/EEC amended by 93/68/EEC and with the
European Low-Voltage Directive 72/23/EEC.
Electrical Safety EN61010-1:2010
Safety requirements for electrical equipment for measurement, control, and laboratory
Double Insulation; Pollution Degree 2
Dielectric withstand Test per 1 min
•
Power to Input/Output:
2300 Vac (3250 Vdc)
•
Power to Input/Output
1500 Vac (2120 Vdc)
•
Power to Relays/SSR Output: 2300 Vac (3250 Vdc)
•
Ethernet to Inputs:
1500 Vac (2120 Vdc)
•
Isolated RS232 to Inputs:
500 Vac (720 Vdc)
•
Isolated Analog to Inputs:
500 Vac (720 Vdc)
•
Analog/Pulse to Inputs:
No Isolation
Measurement Category I
Category I includes measurements performed on circuits not directly connected to the Mains Supply
(power). Maximum Line-to-Neutral working voltage is 50Vac/dc. This unit should not be used in
Measurement Categories II, III, and IV.
Transients Overvoltage Surge (1.2 / 50uS pulse)
•
Input Power:
2500 V
•
Input Power
:
1500 V
•
Ethernet:
1500 V
•
Input/Output Signals:
500 V
EMC EN61326:1997 + and A1:1998 + A2:2001
Immunity and Emissions requirements for electrical equipment for measurement, control, and
laboratory are as follows:
•
EMC Emissions Table 4, Class A of EN61326
•
EMC Immunity
Table 1 of EN61326
UL File Number:
E209855
2
Low-voltage DC power option: Units configured for external low power DC voltage, 12
–
36Vdc.
3
Ibid.
4
I/O signal and control lines require shielded cables, and these cables must be located on conductive cable trays or
in conduits. The length of these cables should not exceed 30 meters.
Omega Engineering | www.omega.com
