25
7 1
7 0
7 2
7 0
7 0
7 2
7 2
7 2
3 6
7 2
3 7
7 2
0 0 0 0
3 7
1
0 0 1 5
3 7
1
0 0 2 0
3 7
2
3 6
7 2
7 1
7 0
0 4 0 3
0 0
1
0 4 0 3
0 0
1
Enter Setup mode
Select Function Group
Enter Function Group
Confirm Selection
Enter
Select SubFunction
Enter
Set Values
Enter and go to next
Zone
EXIT setpoints
EXIT SubFunction
EXIT Function
EXAMPLE:
Set High Alarm Setpoint [over setpoint]
7 2
7 2
3 7
0 0 1 5
=>
=>
=>
=>
7 1
7 0
=>
7 0
7 2
=>
=>
3 6
=>
0 0 0 0
3 7
1
=>
=>
=>
=>
7 1
7 0
0 0 2 0
3 7
2
3 6
7 2
Action
Display Before Display After
Buttons to use
together
one button at a time
together
together
together
[repeat for each zone]
26
6.2
Function [99]
Security
Security password protects all setup functions from accidental or
unauthorized modifications. The security password is factory preset
At 1011 and it can be changed only under RS232 computer pro-
gram. The security can be enabled or disabled within Function [71]
Model Setup. Whenever FN [99] appears, in function window, it
means that the security is enabled and password must be entered one
digit at a time. Using button
enter the correct number in the
flashing digit, then using button shift to the next digit and again
using button enter the correct number. Repeat for all four
digits, then enter with
button . If password is correct the FN
[70] will appear in function window. If not correct the controller will
return to the “RUN” Mode.
If the process times out the display will
return “RUN” Mode.
6.3
Function [70]
Function Set up Control
Function [70] is entered from function [99] or directly from
“RUN” Mode if password security is disabled.
In function [70] , the number 70 is displayed in the function win-
dow, Increment the flashing digit with the button until
required function shows in the upper display, function [71] to
function [78] then enter the selected function with the button
that will display entered function in function window and 70 in the
top display. To confirm the function selection increment the flashing
digit with the button until the upper display matches the
function display. At this point enter confirmation of the selection
with the button
If the process times out the display will
return “RUN” Mode.
If the two displays do not match, the con-
troller will return to function [70].
To return to RUN mode press two buttons and
together
for a few seconds.
6.4
Function Group [71] Model Setup
Function [71] controls functions [31] to [35]
On entering function [71] the function display shows 71. The upper
display shows 31. To select functions
Summary of Contents for CN616TC1
Page 9: ...13 14 ...
