Omega CN616TC1, User Manual

[32]-[35] increment the flashing digit with the button             When the
desired function is displayed enter it with the button            This will
display the desired function in the function display.

If the process times out the display will return “RUN” Mode.

To return to function [70] press two buttons           and           together
for a few seconds.

6.4.1

Function [31]

zone enable

The zone enable function is used to enable/disable any or all of the
zones individually.  If all of the zones are disabled then zone one will
remain enabled by default
In function [31] the function display will show 31, the zone display will
show 1, and the upper display will be blank.
If the zone display is flashing it indicates that the current zone is dis-
abled.
To toggle between enable and disable use the button
To advance to next zone use the button
To save the settings and return to function [71] use the button

6.4.2

Function [32]

password enable

The password enable function turns on/off the password protection for
changing the settings for the unit.  In function [32] the function display
will show 32, the zone display will be blank, and the upper display will
flash 0 or 1.
If the display is 0 it indicates that the password is disabled.
If the display is 1 it indicates that the password is enabled.
To toggle between enable and disable use the button
To save setting and return to function [71] use the button

6.4.3

Function [33]

select model

The select model function sets the type of unit for alarms, relay, degrees
C or F, control mode, and thermocouple as per the table. In function
[33] the function display will show 33, the zone display will be blank,
and the upper display will show a 4 digit model code, digit 1 will be
flashing.

27

To increment the flashing digit use the button
To advance to the next digit use the button
To save the settings and return to function [71] use the button

Four digit model code

Digit 1

0  =  Overheat Alarm

Alarm

1  =  Underheat Alarm

Type

2  =  HI-LO Alarm
3  =  No Alarm

Digit 2

0  =  Latching Rel. °C

Relay

1  =  Latching Rel. °F

And °C or °F 2  =  Non Latching °C

3  =  Non Latching °F

Digit 3

0  =  STANDARD CONTROL

CONTROL

1  =  RAMP AND SOAK 1

MODE

2  =  RAMP AND SOAK 2

Digit 4

0  =  TYPE B

T/C TYPE

1  =  TYPE C
2  =  TYPE E
3  =  TYPE J
4  =  TYPE K
5  =  TYPE R
6  =  TYPE S
7  =  TYPE T

28

2

1 4

3

HI-LO Alarm

Non Latching °F

TYPE K

RAMP AND SOAK 1

Example:
To select “RAMP AND SOAK 1” With type ‘K’ thermocouple °F
with Non Latching HI-LO Alarm, set MODEL as shown below.