PLATINUM
TM
Series Controllers User
’s
Guide
M5451
Omega Engineering | www.omega.com
27
Reference Section: Initialization Mode (INIt)
6.
Reference Section: Initialization Mode (INIt)
Use Initialization Mode to set the following parameters and perform the following functions:
6.1
Input Configuration (INIt > INPt)
Select the Input parameter (
INPt
) to configure the input.
Navigate to the correct setting. Settings include the following:
t.C.
–
Thermocouple Temperature Sensor (entry point)
Rtd
–
Resistance Temperature Detector (RTD)
tHRM
–
Thermistor Temperature Sensor
PRoC
–
Process Voltage or Current Input
Select the indicated setting.
6.1.1
Thermocouple Input Type (INIt > INPt > t.C.)
Select Thermocouple (
t.C.
) as the input type (factory default). Then specify a specific type of
thermocouple or the last selected type will be used.
Navigate to the installed thermocouple type. Supported types are as follows:
k
–
Type K (factory default)
J
–
Type J
t
–
Type T
E
–
Type E
N
–
Type N
R
–
Type R
S
–
Type S
b
–
Type B
C
–
Type C
Select the indicated type.
