PLATINUM
TM
Series Controllers User
’s
Guide
M5451
Omega Engineering | www.omega.com
42
Reference Section: Initialization Mode (INIt)
6.6.3.4
Data Bits (INIt > CoMM > SER > C.PAR > dAtA)
Select the number of Data Bits (
dAtA)
.
Navigate to the desired setting. Settings include the following:
8bIt
–
8 bits used per data character (factory default)
7bIt
–
7 bits used per data character
Select the indicated option.
6.6.3.5
Stop Bits (INIt > CoMM > SER > C.PAR > StoP)
Select the number of Stop Bits (
StoP
).
Navigate to the desired setting. Settings include the following:
1bIt
–
1 stop bit (factory default)
2bIt
–
2 stop bits (provides
a “force 1” parity bit
)
Select the indicated option.
6.7
Safety Features (INIt > SFty)
Select Safety Features (
SFty
).
Navigate to the desired parameter. Parameters include the following:
PwoN
–
Requires confirmation before running automatically at startup
oPER
–
User must select
RUN
when exiting from the
Stby
,
PAUS
, or
StoP
Modes
SP.LM
–
Setpoint limits can be set to limit the values that can be entered
LPbk
–
Loop break enable/disable and timeout value
o.CRk
–
Open circuit detection enable/disable
Select the indicated option.
6.7.1
Power On Confirmation (INIt > SFty > PwoN)
Select Power On Confirmation (
PwoN
).
Navigate to the desired setting. Settings include the following:
RSM
–
Program runs automatically at startup if not previously in fault state
(factory default)
wAIt
–
The unit powers on and then displays
RUN
; press the ENTER button to run
the program
RUN
–
Program runs automatically at startup regardless of previous state
Select the desired setting.
6.7.2
Operating Mode Confirmation (INIt > SFty > oPER)
Select the Operating Mode Confirmation
(oPER)
parameter.
Navigate to the desired setting. Settings include the following:
dSbL
–
Pressing the ENTER button in
Stby
,
PAUS
, or
StoP
Modes will start running
the current program immediately (factory default)
ENbL
–
Pressing the ENTER button in any Operating Menu Mode will display
RUN
;
pressing the ENTER button again will start running the current program
