PLATINUM
TM
Series Controllers User
’s
Guide
M5451
Omega Engineering | www.omega.com
53
Reference Section: Programming Mode (PRoG)
7.3.11
Alarm Off Delay (PRoG > ALM.1, ALM.2 > dE.oF)
Select the Alarm Off Delay (
dE.oF
) parameter.
Set the number of seconds to delay cancelling the Alarm. (The default is 0.) This setting can be
used to prevent Alarm chatter.
Confirm the value.
7.4
Output Channel 1
–
6 Configuration (PRoG > oUt.1
–
oUt.6)
Navigate to the desired output channel.
The number and type of output channels on the
PLATINUM
TM
Series are automatically recognized by the device.
The following output names
display, replacing the generic
oUt.1
through
oUt.6
references used in this document:
StR1
–
Single Throw Mechanical Relay number 1
StR2
–
Single Throw Mechanical Relay number 2
StR3
–
Single Throw Mechanical Relay number 3
StR4
–
Single Throw Mechanical Relay number 4
dtR1
–
Double Throw Mechanical Relay number 1
dtR2
–
Double Throw Mechanical Relay number 2
SSR1
–
Solid State Relay number 1
SSR2
–
Solid State Relay number 2
SSR3
–
Solid State Relay number 3
SSR4
–
Solid State Relay number 4
dC1
–
DC Pulse output number 1
dC2
–
DC Pulse output number 2
dC3
–
DC Pulse output number 3
ANG1
–
Analog output number 1
IdC1
–
Isolated DC Pulse output number 1
IdC2
–
Isolated DC Pulse output number 2
IAN1
–
Isolated Analog output number 1
Note:
All output channels have the same menu structure. However, only those parameters
that apply for the type of output being configured appear
in that output’s menu.
Select the indicated output channel.
Navigate to the desired submenu. Submenus include the following:
ModE
–
Allows the output to be set up as a control, Alarm, retransmission, or
Ramp/Soak event output; the output can also be turned off
CyCL
–
PWM pulse width setting for DC pulse, mechanical relay, and solid state
relay outputs
RNGE
–
Sets the voltage or current range for analog outputs
Select the indicated setting.
