DATA FORMAT SUBMENU:
Preformatted data can be sent automatically or upon request from the controller.
Use the Data Format Submenus to determine what data will be sent in this
preformatted data string. Refer to the iSeries Communications Manual for more
information about the data format. At least one of the following suboptions must
be enabled and hence output data to the Serial Bus.
This menu is applicable for Continuous Mode of RS-232 communication.
Press
d
37)
Display advances to
STAT
Alarm Status Submenu.
ALARM STATUS SUBMENU:
Includes Alarm Status bytes in the data string.
Press
d
38)
Display flashes previous selection for “Status” (alarm status).
Press
b
39)
Scroll through the available selections: NO, YES.
Press
d
40)
Display shows
STRD
stored message momentarily and then
advances to
RDNG
only, if it was changed, otherwise press
a
to
advance to
RDNG
Reading Submenu.
MAIN READING SUBMENU:
Includes Main Reading in the data string.
Press
d
41)
Display flashes previous selection for “Reading”.
Press
b
42)
Scroll through the available selections: NO, YES.
Press
d
43)
Display shows
STRD
stored message momentarily and then
advances to
PEAK
only, if it was changed, otherwise press
a
to
advance to
PEAK
Peak Submenu.
PEAK VALUE SUBMENU:
Includes Peak Value in the data string.
Press
d
44)
Display flashes previous selection for
PEAK
Submenu.
Press
b
45)
Scroll through the available selections: NO, YES.
Press
d
46)
Display shows
STRD
stored message momentarily and then
advances to
GROS
only, it was changed, otherwise press
a
to
advance to
GROS
Gross Submenu.
GROSS VALUE SUBMENU:
Includes Gross Value in the data string.
Press
d
47)
Display flashes previous selection for “Gross”.
Press
b
48)
Scroll through the available selections: NO, YES.
Press
d
49)
Display shows
STRD
stored message momentarily and then
advances to
UNIT
only, if it was changed, otherwise press
a
to
advance to
UNIT
Unit Submenu.
54
Summary of Contents for CNiS16
Page 69: ...NOTES 65...
Page 70: ...NOTES 66...
