31
3.2.11 DISPLAY COLOR SELECTION
This submenu allows the user to select the color of the upper display.
Figure 3.10 Flow Chart for Display Color Selection
ENTER DISPLAY COLOR SELECTION MENU:
Press
a
1)
Press
a
, if necessary, until
CNFG
prompt appears.
Press
d
2)
Display advances to
RDG
Reading Configuration Menu.
Press
a
3)
Press
a
, if necessary, until Display advances to
COLR
Display Color Selection Menu.
Press
d
4)
Display advances to
N.CLR
Normal Color Submenu.
NORMAL COLOR DISPLAY SUBMENU:
Press
d
5)
Display flashes the previous selection for “Normal Color”.
Press
b
6)
Scroll through the available selections:
GRN
,
RED
or
AMBR
.
Press
d
7)
Display shows
STRD
stored message momentarily and then
advances to
1.CLR
only, if it was changed, otherwise press
a
to
advance to
1.CLR
Alarm 1 Display Color Submenu.
The menu below allows the user to change the color of the upper display when
Alarm 1 is triggered.
ALARM 1 DISPLAY COLOR SUBMENU:
Press
d
8)
Display flashes previous selection for “Alarm 1 Color Display”.
Press
b
9)
Scroll through the available selections:
GRN
,
RED
or
AMBR
.
Press
d
10)
Display shows
STRD
stored message momentarily and then
advances to
2.CLR
only, if it was changed, otherwise press
a
to
advance to
2.CLR
Alarm 2 Display Color Submenu.
A color change is based on the Relative Humidity value only.
If this value causes an alarm condition, the upper display will change to
the selected Alarm 1 Color. A color change will occur whether Alarm 1 is
enabled or disabled.
