b. If the pen arms are vertically aligned as shown in Figure 2-10, do the
following and then proceed to Step 3.
Temperature
Pen
Humidity
Pen
M4098-F2-10
Figure 2-10. Vertical Alignment of Pens (Pens Can’t Be Inserted)
(The pen arms must be offset sufficiently to allow for clearance before insertion
or removal of pens are attempted. The pens must be moved electrically.)
• Make sure the recorder door is closed and a piece of chart paper is
installed on the spindle on the chart base.
• Turn on the unit by pressing the power key and wait for the pens to be
far enough apart to remove a used pen one at a time or to insert a new
pen one at a time.
CAUTION
DO NOT ATTEMPT TO OFFSET THE PENS MANUALLY
(BY HAND). THE DRIVE MECHANISM COULD BE
DAMAGED. DO NOT ATTEMPT TO CHANGE THE
PENS WHILE THEY ARE IN MOTION.
• Turn off the unit by pressing the power key again to stop the pen
movement.
3. Open the recorder door by applying downward pressure on the latch button.
4. Remove the pens from the package and the cap from each pen.
5. Insert the blue pen fully into the lower (humidity) holder and the red pen fully and
the second pen (Red for the CTXL-TRH) fully into the upper holder (Temperature
for CTXL-TRH). If you installed the pens correctly, you will hear a click as they
position themselves in the holders. Figure 2-11 shows how to insert the pens.
6. Close the recorder door.
M4098-F2-12
Figure 2-11. Pen Installation
Setting Up the Recorder
2
2-8
!
Summary of Contents for CTXL-PT-W8
Page 64: ...6 2 List of Accessories and Charts Papers 6 Notes...
Page 79: ...NOTES 8 13...
Page 80: ...NOTES 8 14...
