Wireless Temperature/Humidity Chart Recorder
8
8-6
You can have up to a total of 64 wireless transmitters in one location with
different unit ID numbers, so that there will not be any conflict between any of
the transmitters.
If you select the Broadcast option, the transmitter will transmit to any receiver in
the area at the same frequency regardless of its unit ID number.
After saving the new configuration, exit the program. Un-plug the transmitter
from the USB port, turn the battery power back on and you are good to go.
Configuring the wireless Receiver – Unplug the receiver from the chart
recorder. Connect the receiver to the USB port of the PC with the cable provided.
Set the slide switch to “Config”. Run the configuration software. Figure 8-9
shows the main menu of the software. The buttons and the menu selections are
described as follows:
Run – It will display the temperature/humidity in real time from the transmitter.
There is an RF signal strength gauge where it shows the signal strength of
the transmitter being received by the wireless receiver. This is a guide to
show the user how to install the transmitter with respect to the receiver so
that you maintain good signal strength and as a result good and reliable RF
communication.
Program – It will save the new settings to the receiver.
Read – It will read the current settings of the receiver
Settings – It will take you to the communication settings menu
Frequency – You can select between 910/915/920 MHz frequencies.
Time interval – You can select from 2 seconds up to 2 minutes.
Unit ID - You can select a unit ID from 00 to 63.
Figure 8-9. Wireless Receiver, Main Menu
Summary of Contents for CTXL-TRH-W-W9
Page 64: ...6 2 List of Accessories and Charts Papers 6 Notes...
Page 79: ...NOTES 8 13...
Page 80: ...NOTES 8 14...
