10
Section 3.3 Installation and Panel Mounting
Figure 3-4
shows the panel cutout dimensions, the dimensions
for the panel thickness, and the backplate for mounting the unit
in a panel.
Connections will be done after mounting the unit
.
1.
Remove the 2 phillips screws from behind the display (you
don't have to go inside the meter) holding the rectangular
backplate to the meter. Remove the backplate and set aside.
2.
Cut or punch a hole in the panel where you want the meter
to go. The panel can be as thick as 0.25" (6.4mm) to as thin
as 0.03" (0.8mm).
3.
Insert the meter into the panel cutout.
4.
From the rear of the panel, slide the backplate over the case
(smooth side out).
5.
Install the 2 phillips screws to secure the meter in 1/8 DIN
mount. Center the meter in hole prior to tightening screws.
Summary of Contents for DP119-RTD
Page 34: ...27 NOTES ...
