25
This feature selects the method in which the remote start monitors the engine’s run-
ning condition in remote start mode�
“Tachless Hi”
sensitivity mode has an associated base starter output time duration
(see installer feature #5) and monitors the vehicle’s voltage level to determine if the
engine is running� This setting looks for a voltage increase of 0�3v after cranking�
“Tachless Lo”
sensitivity mode operates like the “Tachless Hi” setting but looks for a
voltage increase of 0�5v after cranking�
“Tach Wire”
Before this setting is programmed, refer to the “Violet/White wire” sec-
tion of the installation manual for proper wiring connection and the Tach Learn Proce-
dure� It will crank the engine for up to 3 seconds or until a tach signal is detected�
“Data Tach”
mode operates just like the “Tach Wire” setting except it takes its read-
ing from the D2D data port instead of using the Violet/White wire� Before using, make
sure this function is supported by the Databus Interface module�
“Crank Only”
AKA “blind start” is similar to the “Tachless” settings however, it only
makes one start attempt and does not monitor engine running conditions� This is use-
ful for many “push-to-start” vehicles�
Installer Programmable Features (cont’d)
Feature #8 - Programmable Remote Start Relay
Ignition
(press “
arm/lock
” button to program)
- DEFAULT
Accessory
(press “
disarm/unlock
” button to program)
Starter
(press “
trunk
” button to program)
This feature changes the operation of the unit’s large PINK/WHITE output wire�
This
feature should only be programmed by the installer
�
Feature #9 - Arm, Disarm or Additional Channels
Arm / Disarm
(press “
arm/lock
” button to program)
- DEFAULT
Arm / Channel 5
(press “
disarm/unlock
” button to program)
Channel 4 / Disarm
(press “
trunk
” button to program)
Channel 4 / Channel 5
(press “
start
” button to program)
The system has outputs designed for arming and/or disarming a factory-equipped
security system� These wires may be used instead to provide further system outputs,
which are remotely operated by the controller or transmitter� These outputs are in ad-
dition to the 2nd channel and 3rd channel outputs� As shown in the programming
assignment, the arm, disarm, channel 4 and channel 5 are programmable as various
combinations� For example, if the disarm output is needed, but not the arm output,
then channel 4 may be made available for use�
Feature #7 - Extended Starter Cranking Time
0.7 Second
(press “
lock
” button to program)
- DEFAULT
1.00 Second
(press “
unlock
” button to program)
1.5 Seconds
(press “
trunk
” button to program)
2.25 Seconds
(press “
start
” button to program)
This feature determines the crank time of the 1st start attempt when in “Tachless”
mode. If the engine doesn’t start on the first attempt, it will retry up to 3 more times
extending the crank time by an additional 0�2 second with each attempt��
