Wiring Overview Diagram
4 PIN DOOR LOCK PORT
Lock (-) Out - GREEN
Constant 12v (+) Out - PIN
Unlock (-) Out - BLUE
3 PIN SAT. RELAY PORT (RED)
Start
3
(-) Out - GREEN
Constant 12v (+) Out - RED
Status
3
(-) Out - BLUE
BLACK INTERFACE
MODULE DATA PORT
GREEN INTERFACE
MODULE DATA PORT
TEMPERATURE
SENSOR
WINDOW-MOUNT ANTENNA MODULE
Status Light
Valet / Programming
Button
VEHICLE LEARN PROCEDURE
1. Connect any interface module(s) to the
data port(s) and set for data mode.
2. Turn the ignition key ON
(do not start)
3. Activate remote start
System will chirp/flash lights to indicate engine
type (Default: 1x = Gasoline)
4. Press valet to change engine type:
1 chirp=Gasoline, 2 chirps=Diesel 15,
3 chirps=Diesel 20, 4 chirps=Diesel 30
5. Start the engine with the ignition key
6. Turn the ignition key OFF
System will chirp/flash lights equaling the # of
IGN/ACC/START circuits detected (Max: 4x)
7. Within 20 seconds of Step 6, Activate
remote start. Wait until engine is running
and LED is flashing slow.
8. OPTIONAL: To enable Manual
Transmission Reservation mode, release
and set parking brake again.
System should chirp/flash lights 1x.
9. TO SAVE SETTINGS: Shut down RS by
pressing the BRAKE pedal.
TO CANCEL/START OVER: Shut down
RS by remote or input wire.
~ See Page 10 For Full Details ~
7
