20
FC-21 Flow Computer
SELECT OPERATE STATE
Run
Setup
Test
SELECT EZ SETUP
ARE YOU SURE?
No
Yes
INSTRUMENT TYPE
Rate/Tot Batch
RATE TIME BASE
Sec Min Hour Day
RATE DEC PLACES
0
TOTAL VOLUME UNITS
gal
TOTAL DEC PLACES
0
K_FACTOR TYPE
Avg LinTbl UVC
AVERAGE KA-FACTOR
####### P/gal
LINEAR TABLE KA
Fre01:######## Hz
LINEAR TABLE KA
KA--01:##########
FS ANALOG OUT 20mA
#######gal/m
RATE 00.0 gal/m
TOTAL 0 gal
ENTER
ENTER
ENTER
ENTER
ENTER
6.2.1
TOP LEVEL
SETUP MENU
Menus
Display
Notes
Select Setup to enter the instrument
setup routine.
Press ENTER to begin EZ Setup
routine.
Confirm that you want to run EZ Setup.
Caution:
Any previous program
settings may be lost or reset.
Instrument Type.
Select the appropriate rate time base.
Enter the desired rate decimal location.
0-3 decimal places allowed.
Enter the desired totalizer units label.
Enter the desired totalizer decimal
location. 0-3 decimal places allowed.
Enter the desired K-Factor Type.
If Average selected, Enter the desired
Average K-Factor.
If LinTbl or UVC selected,
Enter the desired frequency/ K-Factor
pair for each point in the Linearization
Table.
Enter a frequency of 0 for any point
other than Fre01 to exit Linearization
Table setup.
Enter the desired full scale setting for
the analog output.
Return to Run Mode
6.2.2
EZ Setup
Submenu
Groups
6.2 EZ Setup
The EZ Setup routine is a quick and easy way to configure the unit for the most
commonly used instrument functions. This setup assumes that you are
measuring Volumetric Flow using a high level, DC Pulsing flow sensor. Entering
the EZ Setup mode automatically sets many features. This may cause any
previously programmed information to be lost or reset. For a complete
customized configuration, see sections 6.3 and 6.4.
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Through
16 Points
