5
1. THE BASIC INSTALLATION PROCEDURE
Is given here as to the basic flow from the installation to operate the CN4800.
For detailed description of each step, see the pages correspondent. See
the section “Operation Procedure” on the pages 33 to 36 for calls and
changes the specific parameter.
Install the main unit on the panel, using the attached panel
mounting bracket. (See page 8 to 18 for details.)
Connect the unit to power supply and input and output
devices. (See page 19 to 29 for details)
Power up, then select and check input types (such as types
of sensors), input temperature range, decimal point used or
not used and so on. In case of the universal output type,
set and check the output switch pins inside the main unit.
(See page 37 to 43 for details.)
Either the conventional PID control mode or the fuzzy
control mode, which is effective in minimizing overshoot
rate and outer condition effects, can be selected. Select by
setting the parameter , where the default set is PID.
(See page 75 for details.)
System power up then, execute auto-tuning to define the
control parameters. (See page 47 to 50 for details.)
Basic preparations are completed. Carry on settings for the
optional functions (alarm, two set points, transmission,
ramp soak, analog output etc.), following this instruction.
Installation of
Main Unit
Connection
Selecting Input
and Output Types
Selecting PID
or Fuzzy
Tuning
Ready
Normal
Operation
See page 44, as setting values (SV) can be set in the same
manner as the Lock parameter on page 44.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Summary of Contents for FUZZY LOGIC CN4800
Page 2: ...M1791 Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOUR...
Page 47: ...45 ogy Group Quality Instrumentation Guaranteed 888 88 SOURCE...
Page 100: ...98 MEMO ogy Group Quality Instrumentation Guaranteed 888 88 SOURCE...
Page 101: ...99 MEMO ogy Group Quality Instrumentation Guaranteed 888 88 SOURCE...
