RTD THERMOMETER
4
Press
button again, then the
MIN
symbol is on the display and also the minimum reading.
Press
button again,
MAX
and
MIN
will blink together. This means that all these data is
updated in the memory and the reading is the present temperature.
One may press
to circulate the display mode among these options.
When the meter is under MAXMIN operation,
and
button
is disabled.
To exit the MAX/MIN mode, one may press and hold
button for two seconds
.
4.9 Auto Power Off:
By default, when the meter is powered on, it is under auto power off mode. The meter will power
itself off after 30 minutes if there is no key operation.
One may press and hold
button and then power on the meter: there will be two
successive beeps to indicate that the auto power off is disabled.
4.10 Low Battery Condition:
The temperature meter low battery indication shows as follows:
Low battery. Replace the batteries.
5. TEMPERATURE MEASUREMENT
5.1 Correct Measurement Method:
The temperature sensor is located at the end
of the metal sheath of the sheath type
TEMPERATURE PROBE. To accurately test
internal temperature insert the probe into the
item you want to measure to a distance of
at least 15 times the diameter of the sheath.
5.2 Connector Configuration:
