3.2.1 ID Number Menu
SEE ID MENU SELECTION IN CONFIGURATION SECTION FOR
ENABLE/DISABLE OR CHANGE ID CODE.
If ID Code is
Disabled
or set as
Default
(0000) the menu will skip ID step
to Setpoint Menu.
If ID Code is set to
Full
Security Level and user attempts to enter the
Main Menu, they will be prompted for an ID Code.
If ID Code is set to
Set Point/ID
Security Level and user attempts to
enter the Configuration Menu, they will be prompted for an ID Code.
ENTERING YOUR NON-DEFAULT FULL SECURITY ID NUMBER.
Press
a
1)
Display shows
ID
.
Press
d
2)
Display advances to
____
.
Press
b
&
c
3)
Press
b
to increase digit 0-9. Press
c
to activate next digit
(flashing). Continue to use
b
and
c
to enter your 4-digit ID
code.
Press
d
4)
If the correct ID code is entered, the menu will advance to the
Setpoint 1 Menu, otherwise an error message
ERRo
will be
displayed and the instrument will return to the Run Mode.
To change ID Code, see ID Menu in the Configuration section.
ENTERING YOUR NON-DEFAULT SET POINT/ID SECURITY ID NUMBER.
Press
a
5)
Display shows
SP1
Setpoint 1 Menu.
Press
a
6)
Display shows
SP2
Setpoint 2 Menu.
Press
a
7)
Display shows
ID
ID Code Menu.
Press
d
8)
Display advances to
____
.
Press
b
&
c
9)
Use
b
and
c
to change your ID Code.
Press
d
10)
If correct ID Code is entered, the display will advance to the
INPT
Input Menu, otherwise the error message
ERRo
will be
displayed and the unit will return to the Run Mode.
To prevent unauthorized tampering with the setup parameters, the
instrument provides protection by requiring the user to enter the ID Code
before allowing access to subsequent menus. If the ID Code entered
does not match the ID Code stored, the unit responds with an error
message and access to subsequent menus will be denied.
Use numbers that are easy for you to remember. If the ID Code is
forgotten or lost, call customer service with your serial number to access
and reset the default to
0000
.
14
