3.2.4 Input Type Menu
Figure 3.3 Flow Chart for Input Type Menu
Input Type (Thermocouple)
ENTER INPUT TYPE MENU:
Press
a
1)
Press
a
, if necessary, until
CNFG
prompt appears.
Press
d
2)
Display advances to
INPT
Input Menu.
Press
d
3)
Display flashes
T.ç
,
RTD
or
PROC
(Thermocouple, RTD or
Process). If the displayed input type is
T.ç
, press
a
to skip to
step 6 (
T.ç
stops flashing).
THERMOCOUPLE SUBMENU:
Press
b
4)
Scroll through the available selection to
T.ç
(flashing).
Press
d
5)
Display shows
STRD
stored message momentarily and then
T.ç
(not flashing).
Press
d
6)
Display flashes previous thermocouple type selection. i.e.
J
(see below for types).
Press
b
7)
Scroll through the available thermocouple types to the
selection of your choice.
Press
d
8)
Display shows
STRD
stored message momentarily and then
advances to the
RDG
Reading Configuration Menu.
Use the Input Type (Thermocouple) (RTD) or (Process) and verify your
Electrical Installation (see
Section 2.3
).
Thermocouple Types:
J, K, T, E, N, DIN J, R, S, B, C
Display:
J K T E N DNJ R S B C
17
