15
DISASSEMBLING AND CLEANING
STEP 1
Switch OFF and unplug the power cord from the wall outlet.
NOTE: • Extract all the remaining pulp in the juicing bowl before stopping the juicer.
• For easier clean up, operate the juicer for an additional 30 seconds after the
juice is extracted.
• When the drum lid is stuck, press the REVERSE – OFF – FORWARD button in this
order, switching back and forth 2 to 3 times to dislodge. Then place both
hands on the drum lid and firmly press down while simultaneously turning the
drum lid to open.
* Fill the juicing bowl with water and run the juicer before opening the drum
lid. It may help to open the drum lid when stuck.
STEP 2
Turn the drum lid counter clockwise to open.
NOTE: • When moving the appliance, do not lift by
grabbing the feeding tube. Always lift the
appliance by grabbing the base or handle.
STEP 3
In order to disassemble, lift off the drumset from the base.
NOTE: • Immediately clean the juicer after
each use by lifting off the drumset from the
base. (Removing the auger and
juice screen while drum-set is still on the
base may cause dripping.)
STEP 4
Remove the auger, juice screen and rotation wiper unit from the juicing bowl. Clean
with provided brush.
NOTE: • Immediately clean the juicer after each use.
If remaining residue in the juicer dries up,
it can make disassembling and cleanup
difficult. The excess build up can cause poor
performance in future uses.
• For easier disassembly, place the topset in
the sink and run the water through from the
top of the top-set.
• Thoroughly dry the bottom of the auger.
