Omega OBFZ91B, Instruction Manual

5

Installation 

Unpacking the Appliance 

Remove the external & internal packaging. 
When unpacking the appliance please check for any damage. If damage is found, do not connect to the 
power source and contact the Authorised Service Provider.  
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will 
reduce the possibility of a malfunction in the cooling system from handling during transportation. Remove 
any protective film from the outer surface. 
Clean the interior surface with lukewarm water using a soft cloth. 

Installing the Refrigerator 

This appliance is designed to be free standing only, and should not be recessed or built

‐

in. 

Place your appliance on a solid, level floor that is strong enough to support the appliance when it is fully 
loaded. Use the adjustable feet at the bottom of the appliance to compensate for any unevenness of the 
floor. 
Allow at least 50 mm of space around the back and sides of the appliance, which allows the proper air 
circulation, and at least 100 mm above the unit. 
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct 
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold 
ambient temperatures may also cause the appliance not to perform properly. Avoid locating the appliance in 
moist areas. 
Plug the appliance into an exclusive, properly installed

‐

grounded wall outlet. Do not under any 

circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning 
power and/or grounding should be directed toward a certified electrician or an Authorised Service Centre. 
After plugging the appliance into a wall outlet (220

‐

240V 50Hz), let the appliance at least 2 hours before 

placing food in the freezer. 

Reverse Door 

Tool required: Philips screwdriver, flat bladed screwdriver, hexagonal spanner. 

•

Ensure the unit is unplugged and empty. 

•

To take the door off, it is necessary to tilt the unit backwards. Rest the unit on something solid so that it 
will not slip during the door reversing process. 

•

All parts removed must be saved to do the reinstallation of the door. 

•

Do not lay the unit flat as this may damage the coolant system. 

•

Two persons required for this installation. 

2. Remove top cover and thermostat knob, then 
place it aside.

1. Remove two screws at rear side of top cover.