08
OFLW1000AW
User Manual
Prior to Installing the Front Load Washer
IMPORTANT:
If the power cord is damaged, it must be
replaced by Residentia Group or one of it’s authorised
service representatives. Please contact 1300 11 HELP (4357)
and ensure the appliance is completely disconnected from
the power supply.
Possible Tools Required for Installation
WARNING:
Please ensure that all power is switched off
before installing the appliance.
•
Drill and Screwdriver
•
Hole Saw Drill Bit for electrical cables & plugs
•
Spirit Level and Tape Measure
•
Pencil and Cable Ties
Installation Area
• WARNING:
Stability is important to prevent the product
from wandering! Ensure the appliance is standing levelled
and stable.
• WARNING:
Make sure that the product does not stand
onto the power cord.
• WARNING:
Make sure to maintain the minimum distance
of 20mm from each wall.
Before installing the machine, ensure that the installation
position adheres to the following conditions:
•
Rigid, dry, and level surface.
•
Avoid direct sunlight.
•
Sufficient ventilation.
•
Room temperature is above 5 °C .
•
Keep far away from the heat sources such as coal
or gas burning appliances.
Unpacking the Appliance
WARNING: Risk of suffocation
Packaging material (e.g. Films, Styrofoam)
can be dangerous for children. Keep all
packaging well away from children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the machine and remove the base packaging.
Make sure the small triangle foam (a) is removed with the
bottom packaging together. If not, lay the unit down on the
side surface and remove it manually.
3. Remove the tape securing the power supply cord
and drain hose.
4. Remove the inlet hose from the drum.
Levelling the Appliance
WARNING:
The lock nuts on all four feet must be screwed
tightly against the housing.
1. Loosen the lock nut.
2. Turn the foot until it reaches the floor.
3. Adjust the legs and lock the nuts with a spanner.
Make sure the machine is level using a spirit level.
Installation Instructions
a
