OmegaView Version 1.4x
2
•
Logger Information:
Gives information about the logger. The type of logger, the internal serial number and
the deployment (how many times the logger was setup to log) are given. You can not change this information.
•
Unit Description:
This field is used to identify the logger to the user. You can enter any text you want here
such as descriptive location, serial number, etc.
•
Sample Interval (Length of Recording)
: Select the sample interval from a predefined list of intervals.
•
: If the interval you want is not on the list, you can set a custom interval using this button.
•
Overwrite oldest samples when full
: Check this box to have the logger continuously record data, overwriting
oldest recorded data. When this box is not checked, logging is stopped when the logger memory becomes full.
•
How to Start Logging
: Logging can start in three ways depending on the selection you make:
o
Logging starts when the Start button is pushed
: Logging will start when the
Start
button is pushed for
about 3 seconds.
o
Logging starts immediately when setup is complete
: Logging will start immediately once the
Continue
button is clicked.
o
Logging starts at this time
: Logging will start at the user specified time. There is no limit how far in the
future you can set the logging to start.
Summary of Contents for OM-70 Series
Page 19: ......
