A
To verify that the USB Interface drivers are installed properly,
check to ensure the Data Logger Software can recognize a
device.
B
When the interface cable is connected to the PC the blue LED
power indicator light should be on. If the indicator light is
not
on, unplug the interface cable, wait 5 seconds and plug it back
into the PC.
C
Start the Omega Data Logger Software. (If necessary, see the
software manual for additional information on the software)
C
Choose
Select Comm Port
from the
Communication
menu.
A sub-menu will appear listing the available communication
ports. If the USB driver install was successful, and the USB
interface is plugged into the PC, then USB1 should appear as
an option.
If multiple USB interface cables are connected to the computer
they will be listed USB1, USB2, USB3, etc. Use this menu to
select the proper device.
E
The USB interface can be configured to work with most Omega
Data loggers by selecting the proper baud rate from the
Select
Baud Rate
option under the
Communications
menu. The baud
rate used by the logger is listed on its label. For example the
OM-CP-QuadTemp communicates at 115,200 baud, so 115,200
must be selected.
Contact US
Website
http://www.omega.com
E-mail Support
cservice@omega.com
Phone
(800) 872-9436
Fax
(203) 359-7700
Address
Omega Engineering, Inc.
One Omega Drive,
PO Box 4047,
Stamford, CT 06907-0047
Test the Data Logger Interface Operation
3
Additional Information
For additional information or troubleshooting assistance, refer to the
User Guide on the Data Recorder Software CD-ROM or call
Toll Free (800) 872-9436.
D
