Quick Start Manual
OM-CP-RFPULSE2000A:
To program the channel on the OM-CP-RFPULSE2000A data logger, start by
switching the wireless mode to
OFF
by holding down the
Wireless
button on the data logger for 5 seconds.
1. Use the USB Cable, plug the USB end of the cable into an available USB port on the PC.
2. Plug the opposite end of the cable into the communication port on the OM-CP-RFPULSE2000A.
3. Open the Omega Software. Locate and select the OM-CP-RFPULSE2000A in the
Connect Devices
panel.
4. In the
Device
tab, click the
Properties
icon. The
Properties
screen will display information about the
device including
Wireless
setting.
5. Under the
Wireless
tab, select a desired channel (11-25) that will match with the OM-CP-RFC1000-EXT
Save
all changes, disconnect the data logger, and return the device to wireless mode by holding down the
Wireless
button for 5 seconds.
Deploying and Activating Devices
1. Plug the OM-CP-RFC1000-EXT into the USB port on the base station computer.
(Additional OM-CP-
RFC1000-EXTs can be used as repeaters to transmit over greater distances)
2. If using multiple OM-CP-RFC1000-EXTs plug each one into a wall outlet in the desired locations.
(If
transmitting over a distance greater than 1000 feet indoors or 4000 feet outdoors or there are walls/obstacles/
corners that need to be maneuvered around, set up additional OM-CP-RFC1000-EXTs as needed.)
3. Verify that the data loggers are in wireless transmission mode.
(See Channel Programming steps above)
On a Windows PC, launch the Omega data logger software program. All active data loggers will be listed
in the software showing that the device(s) are recognized.
4. To activate the data loggers, click on one to highlight, then click the
Claim
icon, and then click the
Start
icon. Do this for each logger in the list that needs to be activate.
