Quick Start Manual
Product Operation (Wireless)
Install the Omega Software and USB Drivers onto a Windows PC.
The OM-CP-RFC1000-EXT interface device comes with a USB cable. Plug one end of the cable into an
available USB port on the PC and plug the opposite end of the cable into the communication port on
the OM-CP-RFC1000-EXT.
Push and hold the wireless button on the OM-CP-RFPULSE2000A for 5 seconds to activate wireless
communication. The display will confirm “Wireless: ON” and the blue LED will blink every 15 seconds.
Launch the Omega Software. All active Omega Data Loggers that are within range will automatically
appear in the connected devices window. Each data logger in the list can be identified by serial number
(
printed on the exterior of the logger
).
To claim a device, select the desired data logger in the list and click the Claim icon.
Select the start method, reading rate and any other parameters appropriate for the desired data logging
application. Once configured, deploy the data logger by clicking the
Start
icon.
To download data, select the device in the list, click the
Stop
icon, and then click the
Download
icon.
A graph will automatically display the data.
Product Operation (Plugged In)
Install the Omega Software and USB Drivers onto a Windows PC.
Before plugging the data logger in the computer, make sure the wireless setting on the device is set to
“Wireless: OFF”. If wireless mode is on, press and hold the Wireless button on the device for 5 seconds.
The OM-CP-RFPULSE2000A comes with a USB cable. Plug one end of the cable into an available USB
port on the PC and plug the opposite end of the cable into the communication port on the OM-CP-
RFC1000-EXT.
Launch the Omega Software. All active Omega Data Loggers that are within range will automatically
appear in the connected devices window. Each data logger in the list can be identified by serial number
(
printed on the exterior of the logger
).
To claim a device, select the desired data logger in the list and click the Claim icon.
Select the start method, reading rate and any other parameters appropriate for the desired data logging
application. Once configured, deploy the data logger by clicking the
Start
icon.
To download data, select the device in the list, click the
Stop
icon, and then click the
Download
icon.
A graph will automatically display the data.
1.
2.
3.
4.
5.
6.
7.
Quick Start Steps
1.
2.
3.
4.
5.
6.
7.
