Omega OM-EL-WiFi Series, User Manual

Use the 

button on the home screen to get more help on setting up your sensors.

Sensors can be confi gured over the air without reconnecting the USB cable. 

When placing the sensor consider local heat sources and radio obstructions. Any physical obstructions 

between router and sensor will affect the signal range. 
The signal icon has three states: 

Changing Sensor Settings over Air

2

the sensor is not 

c o m m u n i c a t i n g 

with the EasyLog 

WiFi software

Flashing

2

the sensor has not 

yet been set-up 

and  confi gured  to 

a WiFi network

Not Displayed

1

the sensor is successfully  

communicating with the 

EasyLog WiFi software

Solid

3

Sensor Placement

Hints and Tips

Important Safety Information

Battery Replacement

The rechargeable battery in the EasyLog product should only be replaced by Omega Engineering.

Repairing or Modifying

Never attempt to repair or modify EasyLog products. Dismantling EasyLog products, including the 
removal of external screws, may cause damage that is not covered under the warranty. Servicing 
should only be provided by Omega Engineering. If the EasyLog product has been submerged in water, 
punctured, or seriously damaged do not use it before returning it to Omega Engineering.

Charging

Only use a USB Power Adaptor or a USB port on another device to charge EasyLog products. Read all 
safety instructions for any third party products and accessories before use with this product. Omega 
Engineering is not responsible for the operation of any third party accessories or their compliance with 

safety and regulatory standards. We do not recommend charging the battery when the unit is at 40˚C 
(104˚F) or above. Some of our products employ safety features to prevent this.

Using Connectors and Ports

Never force a connector into a port; check for obstruction in the port, make sure that the connector 
matches the port and that you have positioned the connector correctly in relation to the port. If the 
connector and port do not join with reasonable ease they probably do not match and should not be used. 

Disposal and Recycling Information

You must dispose of EasyLog products according to relevant laws and regulations. EasyLog products 
contain electronic components and Li-Po batteries and therefore they must be disposed of separately 
from household waste. 

WARNING:

 Failure to follow these safety instructions could result 

in fi re, electrical shock, other injury or damage.